vimarsana.com


I just use a plain knife tool - with a cutting edge square to the spindle centreline, a plan trail angle of *about* 20 degrees and a point radius of about 20 thou/ half a mm. Leftmost tool in the pic.
If I'm roughing, I might angle the toolpost to give a plan approach angle of 10 degrees or so, but as an amateur machinist I'm not often in enough of a hurry to do that.
If I'm finishing, I quite often cock the toolpost over so as to almost eliminate the plan trail angle, and use the trailing edge of the tool almost as a shaving face - small depth of cut, low speed, bit of lube, variable feed depending on results.

Related Keywords

David Fenner ,Harold Hall ,Neil Wyatt ,Ian Bradley ,Simon Williams ,Alf Neal ,Rolls Royce ,Centre Height ,Operator Manual ,Left Hand ,Centre Height Gauge ,Workshop Practice Series ,Tubal Cain ,Tangential Turning Tool ,Sentinel Works ,Eccentric Tools ,Tangential Turning ,டேவிட் ஃபென்னர் ,ஹரோல்ட் மண்டபம் ,நீல் வையட் ,ஈயந் பிராட்லி ,சிமோன் வில்லியம்ஸ் ,ஆல்ப் நீல் ,சுருள்கள் ராய்ஸ் ,மையம் உயரம் ,ஆபரேட்டர் கையேடு ,இடது கை ,மையம் உயரம் பாதை ,பணிமனை ப்ர்யாக்டீஸ் தொடர் ,குழாய் கெய்ன் ,செண்டினல் வேலை செய்கிறது ,விசித்திரமான கருவிகள் ,

© 2025 Vimarsana

vimarsana.com © 2020. All Rights Reserved.