03. March 2021 Thomas Fritsch Chief Editor abk PRESSENBAU UND AUTOMATION has the competent answer and the right machine at hand "There are die-cast parts that must not be broken for further use during deburring, but rather require a clean full cut with the help of a specially manufactured deburring press," explains DYNACST Germany boss Armin Beck in an interview. The current challenge concerns a magnesium die-cast part that will later be used as the rear lock for a luxury Bavarian vehicle. The cast part must not have any fracture surfaces, because an injection-molded part is attached during further processing, and the necessary tightness is only guaranteed with a full cut using a corresponding deburring press.