Evertiq - Sometimes, a Signal Needs to Ride the Rails
Sometimes, a Signal Needs to Ride the Rails Question: I’m designing a signal conditioning block for a precision sensor analog front end. Should I use an op amp with rail-to-rail input? Answer: Possibly—it depends on if the output signal from the sensor forces the op amp to a voltage near the supply rails. For example, if we were to monitor a load current of 0 mA to 500 mA through a precision 10 Ω shunt resistor, the maximum output would be 5 V. If the amplifier supply voltage was 5 V, you would need to choose an amplifier with a rail-to-rail input voltage range.
Source: evertiq.com