"Study on microstructure evolution and mechanical properties of high-st" by Jun Wang, Yao Lu et al.
Defects would occur in the weld joint of the wheel rims during the post-flash butt welding (FBW) process suffering from poor plasticity, which will deteriorate the quality and lifecycle of finish products. Therefore, the FBW process of the 440CL high-strength-low-alloy (HSLA) steel was physically simulated and the influence of flash parameters on FBW joints was systematically evaluated in this study. The results showed that the width of heat affected zone increased with accumulated flash allowance (δf) while declined with accelerated flash speed (vf). The recrystallization level would be inte...