Page 3 - Fender Pro News Today : Breaking News, Live Updates & Top Stories | Vimarsana

From ’50s rockabilly and ’60s pop to ‘70s punk and ‘80s new wave, this 1982 smash encapsulates decades of inspiration

A beauty fan has taken the internet by storm after trying out a new gadget that promises to get rid of split ends in a matter of minutes.

The Vancouver trio on the Latin American influences that flavor new coming-of-age-themed EP, Grown?, and how guitarist Ayla Tesler-Mabe came to lay down tracks on Willow Smith's latest album

Music for a film that never was, this cinematic guitar album features Wally Wilson, Juldeh Camara and Justin Adams of Robert Plant’s Sensational Shape Shifters.

Don't have direct knowledge of the Ender Pro 3 but most 3D printers have fine tuning to get measurements correct. This All3D Article on calibration may help. It is also likely that there are firmware tweaks that will alter the distances travelled in X and Y these may be well buried in the on-board system and essentially tune the stepper motors. Setting the Z axis can be difficult as the layer height is pretty well fixed so everything is a multiple of this and of course the 1st layer will be slightly under height to get good bed adhesion. Z is perhaps best dealt with in the slicer (Cura) where...